催化学报 ›› 2009, Vol. 30 ›› Issue (4): 335-339.

• 研究论文 • 上一篇    下一篇

高光催化活性和易分离回收的硫掺杂 TiO2 纳米管

魏凤玉, 桑蕾   

  1. 合肥工业大学化学工程学院, 安徽合肥 230009
  • 收稿日期:2009-04-25 出版日期:2009-04-25 发布日期:2013-01-21

Highly Photocatalytic Active and Easily Recycled Sulfur-Doped TiO2 Nanotubes

WEI Fengyu*, SANG Lei   

  1. School of Chemical Engineering, Hefei University of Technology, Hefei 230009, Anhui, China
  • Received:2009-04-25 Online:2009-04-25 Published:2013-01-21

摘要: 采用两步水热法制备了硫掺杂的单一锐钛矿型 TiO2 纳米管(STNTs)催化剂. 结果表明, STNTs 的外径为 10~20 nm, 长 200 nm 左右; 掺杂的硫以 SO42- 形态键合在 TiO2 的表面. STNTs 具有较高的光催化活性, 在紫外光和太阳光照射下催化降解甲基橙溶液的一级反应速率常数 k 分别为 0.7992 和 0.5208 h-1, 比未掺杂的 TiO2 纳米管的 k 值分别提高了约 5 倍和 10 倍. 另外, STNTs 可以通过简单的重力沉降从反应体系中分离回收.

关键词: 两步水热法, 硫掺杂, 二氧化钛纳米管, 光催化活性, 沉降

Abstract: Sulfur-doped TiO2 nanotubes (STNTs) were prepared by the two-step hydrothermal method. It has the single-crystalline anatase TiO2 with outer diameter of 10–20 nm and length of approximately 200 nm. The pseudo-first-order reaction rate constant k of STNTs is about 5 times higher under UV-light and 10 times higher under sunlight irradiation than those of undoped TiO2 nanotubes.

Key words: two-step hydrothermal method, sulfur doping, titania nanotube, photocatalytic activity, sedimentation